The module always assumes a 100 mV/g acceleration sensor on the input. When using Function model 0 - Standard, it is possible to configure a different sensor sensitivity using the SensitivitySensor register.

If a different function model is used, for example an SGC controller or bus controller, any conversion to a different sensitivity must be performed manually.

该模块始终假设输入端安装为 100 mV/g 的加速度传感器。使用 Function model 0 - Standard时, 可通过 SensitivitySensor（传感器灵敏度）配置不同的传感器灵敏度。

如果使用不同的功能模型，例如 SGC控制器或总线控制器，任何转换到不同灵敏度的工作都必须手动进行。

Example

举例

Factor = 100 / (sensor sensitivity in mV/g)

系数 = 100 / (传感器灵敏度单位为 mV/g)

All values must be multiplied by the calculated factor. This also applies to the analog characteristic values if the characteristic value calculation is enabled as well as for uploaded time signals and amplitude spectra. Exempt from this are all characteristic values without any units, such as KurtosisRaw, CrestFactorRaw and SkewnessRaw.

所有的值都必须乘以计算的系数。如果特征值计算被启用，这也适用于模拟特征值，以及上传的时间信号和振幅谱。无量纲的特征值除外，如KurtosisRaw, CrestFactorRaw 和 SkewnessRaw.

传感器灵敏度 - Sensor sensitivity

传感器灵敏度 - Sensor sensitivity

Example

举例