<< 点击显示目录 >> 主页  振动监测 > X20(c)CM4810使用手册 > 寄存器说明 - Register description  > 模拟量输入功能 - Analog input functions  > 测量值 - Measured values

 

The last 8 measured values before the X2X cycle are always averaged and transferred on the bus. Here, the direct input signal (raw signal max. 10 kHz) with a sampling frequency of 25.781 kHz is always used and is not mean-adjusted. The value is scaled according to the configuration. (see AnalogInputScale register)

X2X循环之前的最后8个测量值总是取平均值并在总线上传输。在此，总是使用采样频率为25.781kHz的直接输入信号（原始信号最大10kHz），并且不进行均值调整，该值根据配置进行缩放。（请请参阅AnalogInputScale 寄存器）