<< 点击显示目录 >> 主页  振动监测 > X20(c)CM4810使用手册 > 状态监测/振荡分析 - Condition monitoring / Oscillation analyses  > 振动测量技术 - Oscillation measurement technology > 传感器技术 - Sensor technology > 安装传感器 - Installing sensors > 安装步骤 - Installation procedure

 

Depending on the conditions of the location, sensors can be screwed directly onto the surface of the object to be measured.

STEP 1: As smooth and flat a surface as possible is needed to mount the sensors. The required size depends on the sensor; see the data sheet.

STEP 2: An M8 blind hole is needed to attach the B&R sensors.

STEP 3: To further improve the transfer performance, a thin layer of silicon grease can be applied between the object surface and the sensor mounting surface. This is not necessary in most cases and is only useful when measuring particularly high-frequency vibrations.

STEP 4: The sensor should be tightened by approx. 8 Nm when using the M8x1 screw thread. If necessary, the sensor can additionally be secured with adhesive.

 

根据位置的条件，传感器可以直接拧到待测量物体的表面上。

步骤1：: 安装传感器需要尽可能光滑平坦的表面。所需的尺寸取决于传感器；请参阅数据表。

步骤2： 需要一个M8盲孔来连接B&R传感器。

步骤3： 为了进一步提高传输性能，可以在物体表面和传感器安装表面之间涂上一层薄薄的硅脂。这在大多数情况下不是必需的，仅在测量特别高频的振动时才有用。

步骤4： 使用M8x1螺纹时，应将传感器拧紧约8 Nm。如有必要，还可以使用粘合剂固定传感器。